IKOHS CREATE WINDCALM Bedienungsanleitung Seite 7

Blades assembly
Tip: Washersfor blade screws tan be set on
the motor screw twes. Tighten all tne screws once all the bladesare attacned. Beforesworng screws permanently,
repeatwith remainingzladEarms.
Connections panel assembly
Connections panel
Attach the connecticns plate up to the bottom cf the fan by insert ng the set screw heads into the key hole slots.
Rotatethem place and lighte•t them tc secure the plate,
CEILING FAN WITH
LED light panel and lamp shade assembly
Connect t hesingle-pirplugsof thaconnectiorsplatewiththeonesonthe LiD panel,The LEDpanelis magnetized
so il will be attached to the cornectiors panel just by placing them together.
Note-Whileinstallingor removingthe LFDplate.pleasekeepthe 'nsu'ation padsintact carefully Turningte set
screws Civet-tightlyor fast will damagethe insulation pads,
Screw the lamp shade back tc the conne:tions plate.
Blade
arm
screw
LED LICHT
Single-pirtplug
LEDpanel
Washer
2
blate screw ;rior 10 installing blades Aliqn the blade holes with
panel screws
EN