Environmental Protection - Xceed Ex45Js1 Originalbetriebsanleitung

drill or other similar tool from which initial
cutting will begin.
3. ANGULAR CUTTING (See Fig.7-9)
For adjustment of the angle of inclination,
loosen the Allen bolt and screw on the base
of saw.
Move the base plate forward or backward
until the vertical slots align with the two
Allen screws. Then you can rotate the base
plate to the required angle. The angle of
inclination numbers are stamped onto the
curved bracket on top of the base plate to
help you to set the correct angle.
Check the roller support before tightening.
Firmly tighten the Allen screw when finished.
WORKING HINTS FOR
YOUR JIGSAW
1. To avoid the jigsaw springing up and
down when sawing sheets, clamp
wood on both sides of the sheet. When
cutting metal, apply coolant oil along
the cutting line.
2. Adjust the speed to suit the material to
be sawn. We always recommend that
you carry out a test cut first.
3. To use the jigsaw, put the front end of
the base plate on the material and turn
the machine on. Press the machine from
above onto the material and guide the
jig saw along the cutting line.
4. Do not use too much pressure to
achieve the best progress when sawing.
5. When sawing along a marked line use the
marking on the splitting guard as a guide.
6. For exact cutting, clamp a timber batten
onto the material as an aid or use the
parallel guide.
7. For bevels cut, set the base plate in the
required position.
8. Set the base plate to its rearmost
position for cutting close to an edge.
9. If your power tool becomes too hot,
especially when used at low speed, set
the speed to maximum and run no load
12-EN
for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds.
MAINTENANCE
Remove the plug from the socket
before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free
of dust. Occasionally you may see sparks
through the ventilation slots. This is normal
and will not damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
TROUBLESHOOTING
1. If your power tool does not start, check
the plug on the power supply first.
2. If the tool is not cutting properly, check the
blade and the support roller, replace blade
if worn. Also check the cutting angle. The
blade must be at exactly 90° to the base
plate for normal use. (See Fig. 10)
3. If a fault can not be found return the tool
to an authorized dealer for repair.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer
for recycling advice.