Herunterladen Diese Seite drucken

Draper BLT100 Anleitung Seite 2

100 a batteriebelastungsprüfer
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

WARNING
• RISK
OF
l. Working
in the vicinity
battery
operation.
For this reason, it is of utmost importance
these instructions
carefully.
2. TO reduce risk Of battery
manufacturer
and manufacturer
cautionary
markings
3. DO not expose the tester to rain or snow.
4. Do not operate
tester with damaged
5. Do not operate
tester if it has been damaged
PERSONAL
SAFETY
PRECAUTIONS
Someone should be within range of your voice or close enough to come to your aid when you work near a
lead acid battery.
2
Have plenty of fresh water and soap nearby in case battery
3.
Wear complete
eye and clothing
If battery
acid contacts skin or clothing,
4
immediately
flood eye with running
NEVER smoke or allow a spark or flame in vicinity
5.
6
Be extra cautious to reduce risk Of dropping
battery
or other electrical
7.
Remove personal
metal items such as rings, bracelets,
battery. It can produce
PREPARING
TO
TEST
l. Be sure area around battery
by using a piece of cardboard
2. Clean battery
terminals.
3. Inspect the battery
for cracked
4. Add distilled
water in each cell until battery
purge excessive gas from cells. Do not overfill.
5. Make load tests only on battery
6. If necessary
to remove battery
all accessories
in the vehicle
CONNECTION
PRECAUTIONS
l. DO not connect
clips with load switch on tester in the on position.
2. Determine
polarity
negative
(NEG, N, -)
3. When attaching
clips to battery
This tends to keep clips from slipping
4. Position cables to reduce risk of damage from engine parts.
5. Stay clear Of fan blades, belts, pulleys,
TESTING
THE
BATTERY
l. Connect
red clip to positive
above zero; if below zero, the tester is connected
reading
(pointer
on zero), check for a bad connection
2. Push the load switch to the ON position
3. Read battery
condition
LOAD
TEST
0K (GREENBAND)
After
10 seconds
of load.
WEAK
OR BAD,BUT
STEADY
(meter reading
steady after
10 seconds Of load)
WEAR OR BAD AND FALLING
(meter
continues to fall after
I O seconds Of load)
EXPLOSIVE
GASES
Of a lead acid battery
explosion,
follow these instructions
of any equipment
on these items.
cables - replace them immediately.
protection.
wash immediately
cold water for at least ten minutes and get medical
parts and could cause an explosion.
a short circuit high enough to weld a ring or the like to metal causing a severe burn.
is well ventilated
or other non-metallic
Be careful to keep corrosion
or broken case or cover. If so damaged,
above 600F (160C).
from vehicle
are off, to ensure you do not cause an arc.
of battery
posts. The positive
posts, twist or rock back and forth several times to ensure a good connection.
off terminals
and other parts that can cause injury.
post, black clip to negative
and hold for a maximum
and follow instructions
BATTERY
METER
REACTION
BATTERY
Battery capacity
charge by checking
full charge, check for possible
Recharge battery
Battery capacity
partly discharged.
over I .225, battery
battery
and re-test. If cell-to-cell
cell trouble may exist. If charging
the battery
Battery may be defective
switch and note volt meter reaction. If voltage
in a few seconds battery is probably
battery
may be only very run down. For more accurate
and follow above procedure.
is dangerous.
Batteries
that each time before using your tester, you read
and those published
you intend to use in the vicinity
in any way; take it to a qualified
acid contacts skin, clothing
Avoid touching
eyes when working
with soap and water. If acid enters eye,
of battery
or engine.
a metal tool onto the battery. It could spark or short-circuit
necklaces
and watches when working
while battery
is being tested. Gas can be forcefully
material
as a fan.
from coming in contact with eyes.
acid reaches level specified
to test, always remove earth terminal
(POS, P, +) post usually has a larger diameter
and helps to reduce risk of arcing
post. The meter pointer
in reverse polarity,
to battery posts.
Of 15 seconds - until meter pointer
on meter dial.
ANALYSIS
AFTER
10 SECONDS
CONDITION
is good. May or may not be fully charged. Determine
specific
gravity
charging
to full charge.
is unsatisfactory.
Battery may be either: (l) defective
TO determine
which, check specific
is considered
defective.
gravity varies more than 0.025 (25 points),
is either sulfated
or has lost active material.
(e.g. a bad cell). For a quick check, release load
generate
explosive
by the battery
of the battery. Observe
auto technician
or eyes.
with batteries.
attention
do not use tester.
by the manufacturer.
from battery
should move to the right
if so release connections.
OF LOAD
(use hydrometer).
If gravity
system trouble
gravity. If gravity is
If gravity is under 1.225, recharge
does not bring gravity
recovers to 12.0 volts or more
defective.
If voltage recovers
results, check gravity
gases during
normal
for repair.
immediately.
the
with a lead acid
blown away
This helps
first. Make sure
than the
If there is no
stabilises.
state of
is less than
or electrical
drain
or (2)
to full charge level,
slowly,
loading

Diese Anleitung auch für:

3090