Charging External Devices - Xd Collection Rescuewave Bedienungsanleitung

USB PORT CHARGING
The power delivered by the charger must be between min 0.25 Watts
required by the radio equipment, and max 5 Watts in order to achieve the
maximum charging speed.
• Connect the supplied USB cable to a USB power source.
• Plug the USB-C connector into the input port on the side of the radio.
• The charging indicator will flash red while charging.
• A full charge takes approximately 2.5 hours.
• The indicator stays red when fully charged.
• A full battery provides: Up to 15 hours of radio playback (depending on
volume) and 8–9 hours of flashlight use
HAND CRANK CHARGING
• Unfold the handle from the back of the radio and rotate it in either
direction.
• Crank for 3–5 minutes to activate the battery for first-time use.
• Crank at 130–150 RPM to generate power.
• Full charge via hand crank takes approximately 10 hours.
• One minute of cranking provides: 3 minutes of radio playback (medium
volume) and 30 minutes of flashlight use

CHARGING EXTERNAL DEVICES!

This radio can charge USB devices using its internal battery or via hand
cranking.
• Connect your device to the USB output port on the side of the radio.
• Crank the handle or use the internal battery to charge.
• Check your device's screen to confirm charging.
Note: This feature is intended for emergency use only. Do not use the radio
as a regular power bank.
5.