RONDELL RDE-1104 Bedienungsanleitung Seite 13

DO not repair the unit by yourself.
yourself , by any malfunction or after the unit has been dropped,
disconnect it from the electrical outlet and contact any autho-
rized (designated) service center at the contact addresses in
the warranty card and on the website wm-w.rondell.ru
Transport the unit in the original package only.
Keep the unit in a dry cool place Out Of reach Of children
disabled persons.
THIS UNIT IS INTENDED FOR HOUSEHOLD
COMMERCIAL USAGE AND USAGE
AND WORK SPACES IS PROHIBITED.
BEFORE THE FIRST USE
After unit transportation or storage
keep it for at least three hours
switching on.
Take the coffee machine out of the packaging and remove
the packing materials.
Check the unit for damages; do not use it in case of any.
Make sure that the coffee machine operating voltage corre-
sponds to the mains voltage.
Before using the coffee machine for the first time, wash all
removable parts (1, 7, 9, 11, 12, 15)with warm water and neu-
tral detergent and dry them.
OPERATION PREPARATION
Before the first use
Check to make sure that the Brewing Unit (9), Used Coffee
Grounds Container (12), and Drip Tray (7) are properly installed.
Fill the water tank (1) with clean water
Adding coffee beans
Add the coffee beans into the coffee machine (pic. 3).
Coffee Grinding Adjustment
Coffee Grinding can be adjusted during grinder operation.
Open the container lid (2). Turn the grinding degree control knob
(3) (pic. 3). Turn the Adjuster Knob (3) counter-clockwise
more fine grind and a stronger taste,
grind and a softer taste.
Notes: After adjusting the grinding, the adjustment
from the third Cup Of coffee onwards.
Adding ground coffee
Add ground coffee into the coffee maker (pic. 4).
Notes: The Container (2) is only intended for coffee beans, do
not add water, ground coffee, or coffee beans mixed with dense
particles to avoid damaging the coffee grinders.
DO not disassemble the unit by
and
USE ONLY. ANY
IN PRODUCTION AREAS
at low temperature
at room temperature before
(pic. 5).
for
or clockwise for less fine
will persist
13
Drip Tray (7)
When the tray is fully filled, the Float Water Level Indicator (13)
rises, at which point the Drip Tray needs to be drained.
Brewing Unit (9)
Keep the Brewing Unit closed and do not move it during cof
fee making. If the display shows that the brewing unit (9) is not
installed, please, remove it and then insert again as far as it
goes until clicking.
Used Coffee Grounds Container
When the display shows that the container is full, please, empty
the container (12).
Water quality
Poor water quality can damage the unit. Please, observe the fol-
lowing security measures:
Never pour active water into the water tank.
The carbonate hardness must not exceed 5-6' dKH (German
carbonate hardness) or 8.9-10.7' fKH (French carbonate
hardness), and the total hardness must always be higher than
the carbonate hardness.
Minimal carbonate hardness shall be 5' dKH or 8,90 fKH. pH
shall be - 7.
Installing the milk pipe
Install the milk pipe (pic. 1).
FUNCTIONALITY AND OPERATION
Connecting the coffee machine
Insert the power cord into the socket
and connect the unit to the mains (pic. 2).
Note: The operation mode buttons on the control panel (5) are
sensory, you just need to touch the button
sary operation mode on.
Switching the coffee machine on
Step 1
Press the switch (16) tothe position «l» (pic. 6).
step 2
The unit will be switched on and start operation, and the startup
screen will appear (pic. 7). The message
the right bottom corner. Press and wait until the coffee machine
is loaded (pic. 8).
step 3
When the machine is loaded, the menu will appeared on the dis-
play (pic. 9 and 10).
ENGLISH
(12)
on the rear side Of the panel
to switch the neces-
«l_aunch" will appear in