VITRA RIM-EX Gebrauchshinweise Seite 6

1. Introduction of RIM-EX Flushing
1.1 RIM-EX Flushing System system consists of protective badge, functional water
dispersion cell behind and (optional) removable bidet pipe.
2. Rules about Use of Liquid
2.1. Protective badge, functional water dispersion cell and (optional) bidet pipe are all fixed
together and when any of the parts on the set breaks down, the entire part set is required
to be replaced.
2.2. The set which consists
distribution duct is designed to be removed and re-mounted for cleaning purposes. You can
clean the set by pulling the sides of the protective badge and re-mount it. To remove the
protective badge, you should only pull by the sides and likewise, you can fit it by pushing.
2.3. You can clean the protective
2.4. When you want to replace the internal rubber of protective badge, we recommend that
you consult service/after-sale
2.5. Wall Hung RIM-EX system products should be definitely used with compatible
concealed cisterns. Functional problems may occur if flushing systems other than
concealed cisterns
2.6. The tests of wall hung RIM-EX WCs are carried
the following concealed
In other circumstances, your product may splash water or you may experience functional
problem with your product. The details are as follows:
Concealed Cistern
Flushing Flow Rate: 2,1 ±0,1 1/s
Impact Force: 3,8 ±0,1 N between 0,35 s and 0,5 s, maximum
Your product
if the dimensions
not considered.
3. Use and Maintenance
3.1. All badge surfaces should be wiped with soapy cloth and dried with dry cloth every
week for cleaning
3.2. On the areas where water hardness is high, badge surfaces should be wiped more
frequently to avoid build-up of gray stains on the surface.
3.3. To clean all badge surfaces of the product; do not use abrasive sponges whose one
side is green or steel wools that contain hard substances.
3.4. In case of excessive contamination, do not use hydrochloric acid, similar acidic liquids
and powder cleaners which would damage the product surface.
3.5. Chrome-coated
4. Considerations
4.1. The installation should strictly be undertaken by the authorized service.
4.2. While designing the infrastructure prior to the installation, consider the technical
manuals of the product and dimensions
4.3. Wall-mounted
wall-mounted bidets should be installed by the special installation apparatus supplied with
the product. These products should not be directly mounted on the wall.
4.4. Auxiliary materials
should be used in installation.
4.5. Materials that expand while freezing such as cement, plaster, etc. should not be used
in installation.
Detergent
of protective
badge set with a soap-based
service for support.
are used.
cistern standard
Pipe Type: Type C
may splash water or you may experience
indicated
Manual for All Badge Surfaces
purposes.
products should be wiped by a soft cloth damped with kerosene
During Installation
WCs should be fitted to concealed
accompanying
System
Tank and RIM-EX WC
badge, (optional)
out for 6 It in accordance
information
in the catalogue
indicated.
cistern installation
the product, or recommended
5
bidet pipe and external
cleaner.
set out in EN 997
4±0, 1 N
functional
of the concealed
system and
auxiliary materials
with
problem
cistern are
once