Meta System M325 Montageanleitungen Seite 7
Manual
or automatic
La funzione comfort permette di pilotare la salita dei vetri nelle auto che sono dotate di comfort originale,
e non
escludibile.
La selezione Comfort manuale permette che mantenendo
il blocco delle chiusure
La selezione Comfort automatico
chiusure
i vetri saranno
Turn
indicators
The control
unit has two positive
piloting
the turn indicators,
the
doors
are
being
Opening is signalled
indicators
while
the
depending on the type of comfort function selected.
The blink modes
are given in the simple
below:
TYPE
OF COMFORT
FUNCTION
SELECTED
Automatic
Controlled
Car
Finder
The Car-Finder
function
identify in a parking lot. To activate the function,
for
at least
30
sec.
This will be followed
The series of 10 blinks can be interrupted
the blinks,
this action
Window-winder
or Trunk
There is a positive timed output that allows an optional window-winder
locking phase.
The window-winder
output can be used to activate an external trunk unlocking relay (Trunk release) when
programmed
with the PDC/ Alarm Programmer
keys)
that
allow
Dead
Lock
Activation
of the dead
It consists
of an additional
phase and unlocking phase, so as to force the lock's mechanical
unlocked and opened with the internal door opening lever.
Multiple
Commands
Use of the Multiple
It allows
the unlocking
Product
Set-up
It is advisable
to use the portable
PROGRAMMER to change, the operating functions
the alarm control unit preset in the factory and adapt
them to the specific application.
The software
upgrade
available
ON LINE
in the
of web site www.metasystem.it.
Comfort
function
possibile
fare salire i vetri fino al punto desiderato.
implica che premendo
comandati
fino alla chiusura
outputs
so as to warn when
locked
and
unlocked.
by a single blink of the turn
locking
signal
BLINKS
WHEN
BLINKS
UNLOCKING
LOCKING
1
can be used to make the turn
by a series of 10 blinks from the turn indicators.
will also unlock
the doors.
Release
command
the
Trunk
release
lock automatically
0.5 sec command
Commands
function
or locking
command
PDC/CAR ALARM
of the programmer
CAR-ALARM
technical
premuto il tasto "A" del radiocomando
il tasto "A" del radiocomando
completa
TURN
INDICATOR
for
differs,
table
WHEN
Fig. 8
3
indicators
press locking key "A" once the doors have been locked
by pressing key "B" on the remote control. Besides interrupting
and the product is used with M2503
function
to
inhibits
the comfort
transmitted
to the central
automatically
inhibits the Car-Finder and dead lock functions.
of the central
ALARM/PDC
P6987E
of
will be
area
7
senza
dover tenere
PILOTING
LIGHT
BLUE
LIGHT
BLUE
blink,
so that the vehicle
module to be piloted during the
be
controlled
with
and multiple
locks during both the locking
block and prevent the door from being
locks to be repeated
PROGRAMMER
durante
per il blocco delle
premuto
il tasto.
1
1
is easier
to
remote controls
(3
the
third
key.
command
functions.
several
times.
Metasystem
code:
Fig. 9
