Unpacking Instruction; Power Supply; Control Modes - Fuzzix Starry Gebrauchsanleitung

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
INSTALLATION
This product uses a USB power supply. After setting up the bracket and securing the lamp, connect the USB cable to a power
source with a USB interface (e.g., computer, mobile phone charger, power bank, USB socket, etc.). Once powered on, the light
will turn on with the default setting of a 7-color cycle mode.

CONTROL MODES:

Button on the Lamp:
Press the button once to switch between lighting modes.
Press and hold the button for 3 seconds to turn the lamp on or off.
1. Remote Control:
Use the infrared remote control to press the desired function key and control the lamp.
2. App Control:
Download the app on your mobile phone, enable Bluetooth, and connect to "Miracles Star."
•
The 0/1 indicator in the upper left corner represents the Bluetooth connection status:
- 0: Not connected (connect manually).
- 1: Connected (can control multiple lights simultaneously).
•
The hexagonal icon in the upper right corner allows you to adjust the color sequence,
typically RGB. If the controlled color differs from the actual color, you can modify the
sequence:
In the Color Matching interface:
- Click "LED Quantity," enter 24 for the desktop model (50 cm), or 60 for the floor lamp
model (110 cm), and confirm.
- These settings are essential for synchronizing color changes across multiple lights.
In the Mode interface:
- Choose from dozens of lighting colors and dynamic effects.
- Adjust speed and brightness as desired.
In Microphone Mode:
- The lamp changes colors based on the rhythm of ambient sounds.
- You can also select different modes and adjust sensitivity.
REMOTE
1. On/Off
2. W/WW
3. IC Set
4. Auto
5. Green: Up and down opening mode
Blue: Up and down closing mode
6. Energy mode/Flutter running mode
7. Speed/Brightness
8. Flashing mode
9. Transition mode
10. CS: single color
C3: RGB
C7: 7 colors
C16: 16 colors
11. Color jump
12. Flow mode
13. Microphone voice control
14. Running mode
15. Trailing
3