Unpacking Instruction; Power Supply - Fuzzix ALLStar Gebrauchsanleitung

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REMOTE
Function
1 Sets the unit into blackout on or off.
3 Activate the auto show mode for par and light effects.
4 Activate auto show mode for the par.
5 Activate auto show mode for the light effects.
6 Activate sound active mode for par and light effects.
7 Activate sound active mode for par.
8 Activate sound active mode for light effects.
9 Colour change with jump effect (only for par).
10 Colour change with fade effect (only for par).
11 Activate strobe (only for par).
12 Select a different color with these buttons
13 Set the speed using '+' and '-' buttons (note: only available in
the auto shows, colour change, colour fade and strobe
modes).
14 Set the sound sensitivity using '+' and '-' for functions 1 to 4.
CAUTION! The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the foil from the
battery support on the rear side of the remote control. Otherwise operation of the remote control is not possible.
4