Operation; Overheating Protection - Create Retro Pro Bedienungsanleitung

BOIL WATER AT 100ºC
1. Place the appliance on a flat surface.
2. Fill the kettle with the required amount of water (at least 0.5 litres). Observe the water
level indicator.
3. Close the lid by releasing the tab on the handle.
CAUTION: Make sure that water does not splash on the base.
4. Place the kettle on the base and plug in the power cable, the upper LED display will show
100 and the lower one will show the current temperature of the water.
5. Press the power button and the kettle will start boiling the water.
6. When the kettle reaches the temperature of 100ºC it will beep 3 times and stop boiling.
The LED display will show the actual temperature of the water.
7. Unplug the kettle from the electrical outlet. Always keep the lid closed while pouring the
water into a container.
CAUTION: Be careful not to touch the hot water. It may cause burns.
TEMPERATURE SELECTION AND KEEP WARM
1. Fill the kettle with water and place the kettle on the power base. The upper LED display
will show 100 and the lower LED display will show the current water temperature.
2. Press the + or - buttons to set the required boiling temperature (the setting temperature
range is 40 to 90°C for 10 segments).
3. Press the power button, the kettle will start boiling water at the set temperature, the
upper LED display will show the set boiling temperature and the lower LED display will
show the real time water temperature.
4. When the water temperature reaches the set temperature, the kettle will beep once, and
the keep warm icon will light up, the kettle will enter the keep warm mode, and keep the
water warm at the set temperature for 24 hours. The lower LED display will show 24, and
the keep warm icon will light up, the kettle will enter the keep warm countdown.
BOIL WATER AT 100°C AND KEEP WARM TO THE DESIRED TEMPERATURE
1. Fill the kettle with water and place the kettle on the power base. The upper LED display
will show 100 and the lower LED display will show the current water temperature.
2. Press the + or - buttons to set the desired keep warm temperature (setting temperature
range is 40 to 90ºC for 10 segments).
3. Press the keep warm button and then press the power button, the kettle will start boiling
the water at 100°C and keep warm at the set temperature for 24 hours. When the water
temperature cools down to the set temperature, the lower LED display will show 24 and
the keep warm icon will light up, after 24 hours, the kettle will beep 3 times and the keep
warm icon on the LED display will turn off.
The kettle has an overheating protection. This will cause the kettle to switch off if there is
not enough water in the kettle. Allow the kettle to cool down for at least 10 minutes before
using it again.

OPERATION

OVERHEATING PROTECTION

E NGLI SH
9