Inhaltsverzeichnis
Werbung
Getting started
A
1. Before using the blender for the
GB
fi rst time, wash all parts except for
the motor housing. Assembling:
place the rubber seal on the blade
assembly and (A) insert it holding
the blender downwards. Use the
measuring cup and (B) turn clock-
wise to fasten the blade assembly.
Caution! The blades are very
sharp!
Max
90 °C
4. Processing hot liquids: allow hot
liquids to cool down until lukewarm
before fi lling the jug. Fill the jug
only half full and start processing
on low speed. The blender jug can
become very warm – take care to
protect your hands and to ventilate
steam out through the fi ller hole.
Always replace the lid before use.
ELX12757_IFU_Beethoven_Blender_AEG_5lang.indd 17
B
2. Place the blender on a fl at surface
and lock the jug into position on
the motor housing. Put the ingredi-
ents in the jug. (Do not exceed the
maximum capacity of 1.75 litres.)
5. Start the blender by turning the
speed selector to the right. Start
at low speed, then progress to a
higher speed if required. To use the
PULSE function, turn the speed se-
lector to PULSE position and press
the PULSE button.
B
A
3. Close the lid and (A) insert the
measuring cup in the fi ller hole and
(B) lock into position. (You can use
the measuring cup to add ingredi-
ents while the blender is running.
Close the fi ller hole immediately
after, to avoid splashing.)
Caution! When processing hot
liquids, see paragraph 4.
6. Ice crushing: press the PULSE but-
ton for 3-5 seconds several times
until you obtain a satisfactory re-
sult. You can add more ice through
the fi ller hole while the blender is
running.
2009-10-27 15:22:02
D
GR
NL
F
GB
17
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
