Control Panel - Pur Line Rafy 125 Anleitung

CONTROL PANEL

9
4
2
5
2
4
9
1
- TIMER: It can be set between 1 to 24 hours, increase by 1 hour intervals. Digital tube displays the remaining
time.
- LEFT and RIGHT SWING: Press once this button to make horizontal swing of vertical louvers, the SWING
indicator will be displayed. Press again to cancel this function.
- UP and DOWN SWING: The cross blade moves automatically to 90º when the appliance starts. Press this
button to show diffent angles: 90º - 60º to 120º - Any stop - 60º to 120º - Any stop - Auto OFF.
- SPEED: after start Normal or Sleep function, press "Speed" button to choose Low-Mid-High speed.
- COOL: During operation, press this button to start the evaporative cooling
function, to humidify the air, improve the air damp, avoid skin dry and spall.
The corresponding indicator lights Cool and Humidifier will be displayed.
Before press COOL button, make sure water in the tank is always no less
than min. level required. The light of humidifier twinkles, if no water during
operation, and it will buzz. Press again this button to cancel.
- IONIZER: Press once this button to release negative ions into the air, to
freshen the air and care health. Press again this button to cancel.
- Numeric LED display:
Shows air outlet temperature.
Shows setting time (from 1,2,3... until 24 h.)
Fault detection: If the sensor has problems, the digital panel displays E1.
· Do not mix old and new batteries at the same time in remote controller.
· Take out the batteries when the remote is not in use for a long time.
1
8
7
10
6
3
7
8
EN
Botones
1 - ON/OFF
2 - Normal
3 - Sleep
4 - Timer
5 - Left and right swing
6 - Up and down swing
3
7 - Speed
8 - Cool
9 - Ionizer
- ON/OFF: Press once this button to turn on the device.
It will start up with "MID" in 3 seconds and then revert
to work under the memorized status. If for first time
use, it will start up with "MID" in 3 seconds and then
work with "LOW". Press again this button to turn OFF.
6 fan speeds:
- NORMAL (3 speeds): Press SPEED button to select
desired fan speed, MID-HIGH-LOW, in circle turns. The
corresponding air flow speed indicator light will be
displayed.
- SLEEP (3 speeds): Press SPEED button to select
desired fan speed, MID-HIGH-LOW, in circle turns. The
corresponding air flow speed indicator light will be
displayed.
10
Luces LED de indicación
1 - ON/OFF
2 - Normal Speeds
3 - Sleep Speeds
4 - Timer
5 - Left and right swing
6 - Up and down swing
7 - Humidifier
8 - Cool
9 - Ionizer
10 - Numeric display
Remote controller control
panel with the same function
as the unit control panel