EM2GO EM014ACC Bedienungsanleitung Seite 4

Display
The OLED display of the EM2GO charging unit shows
the following information:
1. Operating current
2. Temperature charging unit
3. Charging time
226V kW
4. Charging voltage / power / current
002.44kWh
5. Charging power per hour
6. Accumulated energy consumption 20kWh
7. Status
har in
LED strip display
The LED strip signals the current status of the charger:
Greenl Green2 Green3 Red
Status LED
Green (1) Green (2) Green (3)
Standby One
Flashing
Connected / Ready on
Ongoing Ongoing Ongoing
Charging process
Charging completed On Flashing
Fault mode
Off Off
fault
1. LED Green 1 permanently lit: Standby mode, connected to the mains.
2. LED Green 1 is permanently lit, Green 2 flashes: Device connected, ready for charging.
3. Green LEDs 1, 2, 3 are lit sequentially: charging in progress.
4. LED Green 1 is permanently lit, Green 2 flashes: Charging process is complete.
5. LED flashing red: There is a malfunction.
6. LED permanently illuminated red: There is a grounding fault.
NOTE: If the LED strip flashes red, the protection electronics of the EV charger was
addressed. In this case, please disconnect the mobile charger from the electric vehicle and
from the power grid. Submit the connections, cables and charger to a visual inspection.
5
If there are no visual defects, reconnect everything. If the red LED continues
connect the charger from the electric vehicle and the mains supply and contact your specialist
consultant. Do not use the EV charger.
Operating instructions I Vehicle charging
6A
• Connect the mobile charger unit to a suitable mains socket.
• The current information of the charging station is shown in the display.
• Remove the protective cap from the type 2 plug and connect it to the vehicle's charging port.
Please note that the vehicle is prepared and set for charging. Charging begins.
• Once charging is complete, first remove the Type 2 plug from the vehicle,
the charging unit from the mains. Never disconnect the AC plug from the mains during the
charging process. This may cause damage.
• Put the protective cap back on the type 2 plug.
o
O
Red (fault)
Off
Off
Off
Off
NOTE: On some vehicle models, the charging process does not start automatically.
In this case, the operating button (6) on the charging unit must be pressed.
Flashing
On
No liability will be accepted for any damage caused by incorrect operation. If you need
technical support, please contact our support team via our website www.em2go.de.
Warranty and maintenance
• The warranty period for this charger is two years.
• The warranty expires if:
• No proof of purchase can be provided.
• The warranty period specified by the manufacturer is exceeded.
• The instructions for use, maintenance and storage are not followed.
• Damage or malfunction is caused by the ingress of foreign objects.
• In case Of repair, disassembly or modifi cation by unauthorized
to flash, dis- • Damage caused by force majeure (such as lightning, overvoltage, earthquake, fire,
flood, etc.).
• Damage and malfunctions caused by other avoidable external factors.
• Damage and malfunction caused by improper use of the equipment, such as the ingress of
water or other liquids.
• Damage and malfunction caused by the mains power supply and a voltage not specified for
use with the charger.
We hereby declare, that this device carries the CE mark in accordance
regulations and standards. It conforms
then disconnect
EMC Directive 2014/30/EU, and the Low Voltage Directive 2014/35/EU.
The full text of the EU declaration of conformity is available at the following internet
address: www.d-parts.de/Konfo
Note on environmental protection:
After the implementation of the European Directive 2012/19/EU in the national legal
system, the following applies:
Electrical and electronic devices
Consumers are obliged by law to return electrical and electronic devices at the end
of their service lives to the public collecting points set up for this purpose or point of sale.
Details of this are defined by the national law of the respective country. This symbol on the
product, the instruction manual or the package indicates that a product is subject to these
regulations. By recycling, reusing the materials
making an important contribution to protecting
persons.
Notes
with the
with the fundamental requirements Of the Of
may not be disposed Of with domestic waste.
or other forms Of utilising Old devices, you are
our environment.
6