R.G.V. INDUSTRIAL JUICER Gebrauchsanleitung Seite 39

N1 - BUCKET (BLADE) (3):
1. Do not use abrasive or corrosive sponges or
detergents.
2. Clean it immediately after each use with the
help of a cloth or of a soft brush (toothbrush
type).
☞ Do not touch the small sharp blades at the base of the bucket
(blade) (3). They're very sharp.
Troubleshooting
O
This chapter summarizes the most frequent problems which you can encounter while
using the centrifuge. .
PROBLEM
- The appliance doesn't work.
- The appliance body (7) emanates a
bad smell when you use the appli-
ance for the first few times.
- The bucket (blade) (3) is blocked.
- The bucket (blade) (3) touches the
supply pipe or greatly vibrates dur-
ing processing.
SOLUTION
- The appliance is equipped with a safety
system.
The appliance doesn't work if its have not
been assembled correctly.
Turn the appliance off and check that the
parts have been assembled correctly.
- It's not unusual.
If the appliance keeps emanating this smell
after the first few uses, check the processed
quantities and the processing times.
- Turn off the appliance, clean the supply
pipe and the bucket (blade) (3) and process
a smaller quantity of food.
- Turn off the appliance and disconnect the
power cord.
Check that the bucket (blade) (3) is correct-
ly placed in the juice tank.
The bucket (blade) (3) must perfectly insert
itself on the dragging joint.
Check that the bucket (blade) (3) is not
damaged.
EN
3
39