Safety Notes - Rideet One Bedienungsanleitung

Installation
• Install Rideet One on a bike in vertical position by using centerstand or external stand.
• Before fixing Rideet One to the motorcycle, take note of its Serial Number on the lower
side. You will need it during the Activation process.
• Please note that using the T-tap exposes to the risk of water infiltration in
the installation area around the T-tap, with the risk of high damage to the
motorcycle electric system. After the installation, protect the area using
insulating tape and any other solution to prevent infiltration.
• Always make sure that there is no conductive connection between the
positive pole of the battery and its negative pole or another ground point
such
• After the installation, be sure that all the parts are strongly fixed.
• When fixing the Rideet One, position it according to the Positioning
Guidelines in the Installation section on rideet.com/support
Rideet app.

Safety notes

• Before installing Rideet One, be sure that the motorcycle is in a stable and steady
position to avoid possible falls.
• When installing Rideet One, a ways use protective equipment such as,
but not limited to, insulated gloves to prevent electric hazards.
notes
as the frame.
or in the
English
3