Shore ROLATV Installationsanleitung Seite 3

3. If necessary, connect the fans of the left, middle, and
right cabinets to USB Extender 2.
Wiring hole
Connect through the middle wiring hole
1. Initial Testing
Use the remote control to turn on the projector and test if the expandable stand and floor rising screen are working properly.
If not, please check the connections
2. Position Calibration
After everything is working properly, use the remote control to adjust the position of the projector and screen. After adjusting
to the suitable position, let it sit for more than 30 seconds, then cut off the power and restart the power of the TV cabinet to
successfully save the cabinet position.
Remote control
telescopic
Enjoy your movie time.
Wiring hole
Adjust Memory Position
of the projector, cabinet, or floor rising screen with the USB.
4. Connect all power supplies; at this point, the cabinet's
expandable stand will retract.
Adjust to appropriate size