Getting Started; Set-Up And Use - Labelmate Universal Label Slitter Bedienungsanleitung

Getting started

SET-UP AND USE

• 1. Place the Label Slitter so that it is perpendicular to the web of labels to be slit. Observe the Paper Path Label on the
Slitter.
• 2. Being careful to avoid contact with the cutting blades, feed the label web under the Rotating Paper Guide
• 3. Adjust the position of Fixed Paper Guides to the width of your label web. Only finger tighten the screws.
• 4. Pull the label web through and affix it to the label rewind core on the Label Rewinder.
• 5. Being careful to avoid contact with the cutting Blades, adjust the position of the Blade Holders as desired. To do this,
loosen the set screw of the Blade Holders and slide the Blade Holders in or out as needed. Finger tighten the set screw
to hold the adjustment. Do not over tighten.
• 6. Start the Label Rewinder and the printer (if used). Adjust the speed of the Label Rewinder as required. See the CAT-3
User Manual for details.
When the slitting action becomes impaired because of dull Cutting Blades, the Blades can be replaced.
•
Labelmate.com