Tip:
� It is not recommended to use the device for more than 20
minutes at a time.
� Your vision may become blurry for a while, as expected after
using the device. It is advised to close your eyes for a few
minutes until your vision goes back to normal.
Power button:
Press and hold for 2s to turn on/off the device.
Short press to cycle through 3 spa modes
(default: cooling mode).
� Each press is accompanied by a beep sound.
Spa Mode
Cooling
Heating
Cooling &
Heating Cycle
Note:
� As the device needs to dissipate the heat to support the
cooling function, it is not recommended to operate the cooling
mode in succession. It is recommended to operate this mode
every 30mins.
CHARGING
a. Charge the device using the provided charging cable and a DC
5V 1A mobile charger (not included).
b. It takes about 2.5h to fully charge the device.
Status
Low battery / Charging
Fully charged
Overcharging (at the voltage of 6-30V)
Indicator
Temperature Timer
Light
Blue
20℃ / 68℉
Red
39℃ / 102℉
Purple
20-39℃ / 68
-102℉
3mins
10mins
8mins
Indicator Light
Flashing red
Solid red
Flashes red quickly for 1 minute
EN - 05
Support use
upon a full charge
about 6 sessions
about 6 sessions
about 4 sessions