Changing Direction Of Rotation - Brel Rw100 Installationsanleitung

Step 1
Add remote control
Method 1
Power on
During setup, the time between two actions must be shorter than 10s, otherwise the receiver
will exit programming mode.
Method 2
Power on
Power on
Step 2

Changing direction of rotation

Power on
Step 3
Favorite position
1x P2
P2
Go to the Press the P2 button. The
desired motor moves up/down
favorite
position
Press and hold the stop button for 3 seconds to go to the favorite position.
Repeat this procedure to delete the favorite position.
LED blinks
1x
L N N NC U NC C K
P1 x 2s
LED blinks
1x
P2
a
P2 x 1
Press the button up
and down at the same time
until the motor jogs
1x 1x STOP
Press the STOP button. The
motor moves up/down
LED blinks
L N N NC U NC C K
Release button
LED blinks
1x
P2
a
P2 x 1
The direction of rotation
is changed
1x
LED blinks
3x
Stop button x 2s
LED blinks
3x
P2
b
P2 x 1
1x STOP 2x
Press the STOP button. The motor
moves up/down twice
Page 9
Receiver is
connected
Receiver is
connected