BREL RW100 Installationsanleitung Seite 11

Extra functions
External switching mode
NB! This is only possible after setting the end positions
Push button switching mode (factory setting)
1x
P2
Press the P2 key once.
the motor moves up and
down once
The Push Button Switch Mode works as follows:
Press the up button -> product goes up -> press the up button again -> the product stops.
Press the down button -> product goes down -> press the down button again -> the product stops.
Mechanical switching mode
1x
P2
Press the P2 key once.
the motor moves up and
down once
The Mechanical switching mode works as follows:
Press and hold the up key -> product goes up -> release the up key -> the product stops.
Press and hold the down key -> product moves down -> release the down key -> the product stops.
Electronic switching mode
1x
P2
Press the P2 key once.
the motor moves up and
down once
The Electronic Switch Module works as follows:
Press the up or down button -> product goes up or down -> press stop -> the product stops.
Single push button switching mode
1x
P2
Press the P2 key once.
the motor moves up and
down once
The Single Push Button Switching Mode works as follows:
Press the button -> product goes up or down -> press the button -> the product stops.
1x
P2
Press the P2 key once.
the motor moves up and
down once
1x
P2
Press the P2 key once.
the motor moves up and
down once
1x
P2
Press the P2 key once.
the motor moves up and
down once
1x
P2
Press the P2 key once.
the motor moves up and
down once
1x
Press the STOP button, the
motor goes up and down
once and beeps once
2x
Press the STOP button, the
motor goes up and down
twice and beeps twice
3x
Press the STOP button, the
motor goes up and down 3
times and beeps 3 times
4x
Press the STOP button, the
motor goes up and down 4
times and beeps 4 times
Page 11