English - Mds Md200 Bedienungsanleitung

English

1) OPENING/CLOSING THE CHIN GUARD
1
2
2) VISOR
3
4
MD2
THIS HELMET'S SHELL IS MADE OF THERMOPLASTIC
THIS HELMET'S LINER IS MADE OF POLYSTIRENE (EPS)
To open the chin guard, press the red button inside the guard (1).
Keep the button pressed and raise the guard until it is in the correct
position (2).
To close the chin guard, lower it until you hear it click into the closed
position.
Make sure that the chin guard is locked in position by trying to raise it
without using the red button.
We recommend that you carry out the following tasks laying the
helmet on a flat surface.
2.1) Visor mechanism
Upper lug seat
Visor lock
Visor lock slider
The non-scratch polycarbonate visor has a toothed mechanism that
meshes with a corresponding system on the helmet. The teeth on the visor
mesh with those on the helmet system to ensure that the visor remains
stable while being opened and while it is in different positions.
Upper lug
Lower lug
To remove the visor, raise it to the fully open position. Pull the tab on one side of
the visor lock (3) downwards and take out the lugs of the visor (4). Repeat this
operation on the other side of the visor and remove the visor.
To fit the visor, with the visor in the fully raised position, fit the upper lug (4) into its
position on the helmet visor seat (3). Now fit the lower lug (4) into its position on the
visor mechanism (3) while pulling the tab downwards (3). Repeat this operation on
the other side of the visor. Lower the visor and make sure that it is working
properly.
6