Using Your Ice Maker - Coca-Cola Seb-28Cc Bedienungsanleitung

USING YOUR ICE MAKER

1. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the MAXIMUM water level mark.
2. Press "ON/OFF" button on the control panel to begin the ice making cycle.
3. If the room temperature is lower than 15°C, it is recommended to select small ice cube in
order to avoid ice sticking together.
4. The ice making cycle lasts approx. 8 to 13 minutes, depending on the room temperature.
The recommended room temperature is 10°C to 30°C
5. If water pump can't inject water, the ice maker will stop automatically, and the "Add
Water" indicator will be on. Press "ON/OFF" button, ll water up to the max. water level
mark and press "ON/OFF" button again to turn on the unit again. Allow the refrigerant
liquid inside the compressor at least 3 minutes to settle before restarting.
6. The unit stops when the ice basket is full and the "Ice Full" indicator will be on.
Warning: Direct sunlight or sunlight re ection may cause .
7 sensor malfunction. If the unit doesn't stop even ice cubes obstruct sensor,
move the unit where no sunlight.
8. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.
If unit isn't to be used, drain all the water and dry the tank.
TROUBLESHOOTING
PROBLEM
"Add Water" indicator is
on.
"Ice Full" indicator is on.
Ice cubes stick together.
Ice making cycle is
normal but no ice
formed.
POSSIBLE CAUSE
Lack of Water.
Ice is full in basket.
The ice making cycle is too long.
Water temperature in inner
tank is too low.
Room temperature or water
temperature in inner tank is too high.
Refrigerant in cooling system leaks.
Pipe in the cooling system is blocked.
SOLUTION
Stop the ice maker, ll water,
and press "ON/OFF" button
again to restart the unit.
Remove ice from ice basket.
Stop the ice maker and restart it
when the ice blocks melt.
Replace the water. Temperature
of water recommended at
5-30°C
The room temperature should be
10-30, water temperature
should be 5-30°C
Verify by a quali ed technician.
Verify by a quali ed technician.