Ninka Qanto R4 Bedienungsanleitung Seite 3

EN General assembly instructions
• Anyone who performs connection or assembly work on Qanto must
have access to these assembly instructions. Follow these instructions.
Non-observance of the abovementioned instructions can lead to acci-
dents resulting in severe personal injury.
• Assembly may be performed by expert personnel only.
• If Qanto is not installed as a corner cabinet, ensure there is sufficient
clearance from the edge of the counter.
• If the product is visibly damaged, it must not be installed.
• During the installation of Qanto, make sure there is sufficient clearance
for the movement of the lifting system. When Qanto is extended upward
and to both sides, a clearance of about 200 mm to other cabinets or shel-
ving must be observed.
• A clearance of 300 mm must be observed between Qanto and a gas
stove.
• The electrical system of Qanto must be accessible (e.g., a double so-
cket under the cabinet near the base).
• Make sure the cables are undamaged.
• Before connecting the electrical drive to the in-house power mains,
compare the voltage of the power mains with the input voltage specified
on the type plate. The mains voltage and permissible input voltage must
be identical. If not, Qanto must not be connected.
• If the control unit causes unusual noises or odours during operation,
interrupt the power supply.
3
Qanto_Id_A4_00000.50.65053_DE • EN • FR • ES_23.03.2018