Inventini PASCAL Aufbauanleitung Seite 6

INSTRUCTIONS
Fig. 1
Fig. 3
Fig. 4
REPAIR
6
Inflate setup
Deflate setup
Fig. 2
1. Choose a flat even spot where you want to pitch the product.
Take the product out.
2.
Anchor first leg of arch to the ground by inserting spike into the
rings at the base (Fig. 1).
3. Clip the first end of the rope to the arch leg. Repeat for each rope.
4.
Make sure the pump valve is in the INFLATE SETUP (Fig. 2).
5.
Use the pump to inflate the product until you feel it is completely taut.
6. Anchor the second leg of arch to the ground (Fig. 3).
7. Clip the second end of the rope to the torsion anchor, stretch the rope,
and hammer the anchor. Repeat for each rope (Fig. 4).
1. Unhook the rope and remove the torsion anchor and spikes from
the base.
2. Set up the pump valve in the DEFLATE SETUP (Fig. 2)
3. Put legs together and start rolling them from inside to the valves.
4. Put the arch together and pack into a carry bag.
A small hole can be repaired by using repair kit - glue and foil.
If the product foil is damaged:
1. Locate the damage.
2. Degrease the surface.
3. Apply the adhesive to the hole, taking care that the adhesive does
not get inside the product.
4. Apply the foil patch.
5. Wait 60 minutes for the adhesive to fully bond.
There is a possibility of sending the product back to the manufacturer.
ASSEMBLY
DISASSEMBLY
DAMAGE
PASCAL ARCH ASSEMBLY INSTRUCTIONS