Safety Rules - Inventini Pascal Aufbauanleitung

SAFETY RULES

RECOMMENDATIONS
CAUTION
GENERAL TERMS
OF WARRANTY
www.inventini.co
1. Inflatable arch is not adapted to severe weather conditions
such as strong winds, heavy rains, storms or hailstorms.
2. In case of strong winds (over 38 kph), disassemble the arch.
Mechanical damage resulting from non-compliance with the
instructions is not covered by the warranty.
3. You shouldn't leave your product unattended.
4. Keep the product away from sources of heat and open flames.
Please do not place any sources of heat direclty at the product
beacuse the materials can melt at high temperatures.
5. By special order, you can have your product made of flame
retardant fabric (which meets the standards of B1 requirements).
1. Read these instructions carefully before you get to work.
2. Be cautious while setting up the product to avoid being hurt and
prevent other damage.
3. Before disassembling the structure, the product must be thoroughly
cleaned. Any spots or stains on the fabric should be removed
immediately with a warm damp cloth. Do not use pressure washers
Follow the instructions on the label.
4. Storing a dirty or damp product can result in a breakdown of the
materials as fabrics tend to mold, mildew and/or rot. Before putting
your product in its transport bag for storage, make sure it is
clean and dry. Store it in a dry place to avoid moisture contamination.
In case of bad weather, repack your product to avoid damage,
but as soon as it's possible, unpack it once again to let it dry.
5. With recurring gusts of wind, check anchoring systematically.
6. Arch may be used with wind up to 38 kph. During stronger wind,
it is recommended to disassembling the product.
7. Do not cover the safety valves in any case.
8. Take special care when transporting and storing the product.
9. Do not expose the product to mechanical impact, pressing with other
products or contact with sharp objects, as this can lead to damage to
theinsert and the product tipping over.
The air in the product changes it's volume under the influence
of temperature. High temperature increases the volume of air.
The product becomes more taut.
Low temperature reduces the volume of air.
The product becomes less taut.
General terms of warranty can be downloaded from the
manufacturer's website.
EN
5