Segway ninebot Z10 Benutzerhandbuch Seite 5

4 Diagram
Handle
Rear
Light
Pedals
Power
Power on/off
Switch
A blinking Bluetooth icon indicates that the Bluetooth
Bluetooth
phone; an illuminated Bluetooth icon indicates that the App is connected
Each block represents 20% of power level When the battery is nearly empty the icon blinks
power
Please charge before use again. When the power level decreases to a certain level, your Ninebot
Level
ZIO gradually reduces the speed limit to ensure safety. Use the App to read the remaining power
and estimated remaining range
Speed Limit Mode can be used for the new rlder to practice
Speed
activate your Ninebot ZIO the speed limit of the vehicle will be gradually increased. When the
Limit
Ninebot ZIO is in the safety state, the Speed Limit Mode will be turned on automatically,
vehicle will be limited to a lower speed. Users can customize
[1] The dashboard contains a light sensor, please do not block or cover it so the light can turn on/off automatically.
Power Switch
Dashboard
Charging Port Dashboard :
Headlight
(9)
Speed Limit
Power Level
Bluetooth
is turned on but not connected to the mobile
to the Ninebot ZIO
Follow the instructions on the App to
and the
the speed limit
Portable Mode
Ninebot ZIO is set to portable mode when the vehicle is
delivered If you lift the handle when the vehicle is
powered on, the wheels will stop turning The vehicle
will run normally when you reset the handle
You can switch off portable mode on the phone app If
you do, do not lift the handle when the vehicle is
powered on, or the wheels will still turn and may cause
injury
Use of Trolley Handle
After the installation of the trolley handle to Ninebot
ZIO, the handle can be pulled out to move the vehicle in
non-riding state, and the handle can be pulled back
after use
Note:
Do not lift the vehicle up directly by the trolley handle
Do not use the trolley handle while riding.
Pick up the vehicle only by the handle