VEVOR TD-059-02 Bedienungsanleitung Seite 5

ASSEMBLY INSTRUCTIONS
1) Install kick arm to stand body with screws.
2) Put on the washers and use tools to screw up the nut.
NOTE
It will be much easier to lift up your bike if you set the top plate to 5mm
lower than your bike's ground clearance.
CAUTION
1) After you set the stand's height, please tighten "Screw lock nut" against
"Lifting Shaft".
2) This Stand's maximum weight capacity is 1200lbs
3) Don't sit on the bike while it is on the stand.
4) When released, the kick arm will come up fast. Please be careful that
your leg or other body parts do not get caught between the kick arm and
top plate or your bike.
5) After the motorcycle has been lifted, use "Safety hold hook" to help
prevent an unintentional descent.
Figure 2
- 4 -