Sauer Si-RT2 Schnellstartanleitung Seite 2

Quick Start Guide
English
These operating instructions describe how to use and connect the Si-RT2, Si-RT5, Si-RT7, Si-TH4, Si-RP4 and
Si-RV4 probes properly.
Please refer to the operating instructions available at sauermanngroup.com for safe use of the manifolds
and detailed information.
Do not give these devices to a child.
1. Insert batteries on Si-RT7, Si-TH4, Si-RP4 and Si-RV4 wireless probes
Type of batteries: 3x LR03 AAA 1.5 V alkaline batteries
Example with a Si-RP4 or Si-RV4 probe:
Move the batteries
cover latch
upwards.
For Si-TH4 and Si-RT7 probes, there is no batteries holder. Simply put batteries respecting the polarity.
2. Wireless probe On/Off button
ON: Briefly press the button. LED turns on.
OFF: Press and hold the button for 3 seconds. The LED flashes 3 times and goes off.
3. Connect a wireless probe to a manifold
Before using a probe for the 1
10:10
Measurements / Tests
Measurement settings
Wireless connection
General settings
Fault tree analysis
Data recording
Device information
Go to Wireless connection with ▲
Remove the batteries
Remove the
holder and insert
batteries cover.
time, this probe must be paired with the manifold.
st
Menu
>
>
>
>
>
>
>
and ▼ and press OK.
Insert the batteries holder respecting the
polarity with arrow pointing up.
batteries.
10:10 Wireless connection
Wireless
Scan devices
Registered devices
Wireless is ON. Go to Scan
devices and press OK.
Put back the
batteries cover.
10:10 Scan devices
Si-RV4
ON
>
>
Turn on the
wireless
probe.
The probe is detected.
Press OK
10:10 Available Device
Connected
Name
Type
Serial number
Address
Firmware version
Probe is connected: its features are
shown. Probe is ready to measure
and display data.
Move the batteries cover
latch downwards.
XXXXXXXXXXXX >
1
Si-RT7
Temperature
XXXXXXXXXXXX
xx:xx:xx:xx:xx:xx
x.x