BABYTREND Smart Steps My First Rocker 2 Bouncer Bedienungsanleitung Seite 5

ASSEMBLY
A�ach the vibra�on unit
2
Attachment parts
Gather the parts and locate
the holes of the padded
support tube.
Register corresponding holes
of the vibration unit. To see
inserting orientation, refer
to the Frame Orientation
Diagram on page 5
Screw into the frame
Correct
7
Copyright © 2023, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
*
*
and will require removal for assembly
Tighten
Screws
Inser�ng the padding
3
Rear frame view
upside down and slip the cover
NOTE: Keep buckle straps over
the tubes at all times.
Pull the fabric over the
vibration one side at a time
until completely wrapped
Copyright © 2023, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
A S E S M B Y L
entry
of fabric
covering
down
Top arch
8