strex SP304 Bedienungsanleitung Seite 45

INSTALL AND TAKE OUT THE BATTERY
Take out the battery:
Removing the battery:
a) Power o the Camera with the ON/OFF button.
b) Open the battery compartment on the bottom of the Camera.
c) Pull the battery out.
d) Close the battery compartment (to keep dirt and dust out).
Installing the battery:
a) Open the battery compartment on the bottom of the Camera.
b) Slide gently the battery into the battery compartment. Check the polarity and install the
battery correctly.
c) Close the battery compartment (to keep dirt and dust out).
d) Power on the Camera with the ON/OFF button.
Charging the Battery
WARNINGS:
-
-
-
-
● Ensure that the device is switched o .
●
Attach the supplied USB cable to the charging port of the Camera and plug the other end of the
cable into a 5V/1A USB adapter (not included). We recommend using a USB adapter, however,
using the USB interface of a computer/laptop or a powerbank is also possible.
To shorten the charging time, the 5V/1A USB adapter is the best choice.
-
Some USB outlets might have insu cient output current, which will slow down the charging
-
speed or even hinder the charging.
When the device is charging, the red charging indicator light is ashing.
●
● When the battery is fully charged, the red charging indicator light stops ashing and it remains
on.
● Unplug the USB cable when the charging is finished.
● The charging time from an empty battery to a full battery takes 1.5 hours.
Fully charge the battery of the Camera before you use it for the
first time or after a long period of disuse.
To extend the life of your battery, drain it every 3 months and then
give it a full charge.
Never charge a fully charged battery. Overcharging shortens
battery life.
Always follow the safety instructions as described in the chapter
"SAFETY INSTRUCTIONS - Battery Safety".
45