STARLINK Cable Routing Kit Bedienungsanleitung Seite 8

INSTALLATION
Instructions
Unplug your Starlink from wall before beginning the
installation process. Do not drill through studs, pipes
or electrical wiring. Before you drill, consider using an
electrical / stud finder to avoid pipework and wires.
Avoid drilling near power outlets and light switches.
1. Use provided drill bit to drill starter hole at
a slight angle from the inside all the way
through the outside of the structure.
2. Use the provided spade bit to drill larger
inside hole and outside hole.
3. Use the cable routing tool to
funnel your Starlink cable from
inside to outside.
* Do not plug in
4. Use the wall clips as shown to secure your
cable and avoid water damage. Place wall
clip over wire. Align wall clip with screw over
wall anchors. Screw wall clip into anchors.
* Loop cord below hole to avoid leakage
5. Install the provided grommets on both the
exterior and interior wall.
ENGLISH