AROHA Smart Connect SM11W Bedienungsanleitung Seite 6

EN
Figure 1: Add Device in app
Figure 2: Turn on Bluetooth in app
05
4. Activate pairing mode by pressing the test
button 4 times within 1 second. If this is done
correctly, the red LED will flash rapidly. After a few
seconds this will change to a green LED that
flashes rapidly for 1 minute. Within this minute you
can connect the detector to your app.
5. Click on the "+" in the top right corner of the app
home screen. Then choose "Add device", as you
see in Figure 1. The app will now automatically look
for devices that are in pairing mode. Follow the
steps as described in the app.
If the app itself does not yet have permission to
use Bluetooth, click on the notification and follow
the steps to allow the app to access Bluetooth as
you see in Figure 2.
Frequently Asked Questions
Alarm: If an alarm sounds when you try to
activate pairing mode, a test is activated
because you did not press fast enough. After
the alarm stops, try pressing the test button
again 4 times as quickly as possible within 1
second.
Low battery: The first time the detector is
connected, the app may incorrectly report that
the battery is low. Push the test button or
disconnect the smoke detector and then
reconnect it. If the notification is given again by
the app, please contact us.