4. TROUBLE SHOOT
Now remove the cover of the sound controller and press the white button.
white button
Within ten seconds, press the button next to the battery again, two seconds
later press and hold the button on the back of the board. When the LED on the
Bluetooth button flashes green, the Sound Controller has been successfully
tuned in to the Bluetooth button.
Relearning the OBD2 connector with the sound controller
Disconnect the Sound Controller from the power supply. Now remove the cover
of the Sound Controller. Press and hold the black button on the side. Reconnect
the Sound Controller to the power supply. After five seconds, release the button.
When the status LED lights up green, the OBD2 connector is connected to the
Sound Controller.
black button
16
Legal
RIGHTS & NOTES
COPYRIGHT, OTHER RIGHTS NOTICE AND GENERAL NOTES
The REMUS trademark, including corporate logos and emblems, are subject to
copyright as well as trademark rights of REMUS, its licensors, or third persons
authorizing REMUS to use them. Any reproduction, technical or other
manipulation, translation, or other use of the copyright and/or trademark rights
contained herein is prohibited without the explicit prior written consent of REMUS.
The same especially applies to the entire contents of this manual and/or any of
its parts, including but not limited to technical specifications, instructions, graphs,
photographs, and so on included in this manual.
The photographs and other illustrations in this manual are symbolic and are
intended to help represent individual steps for proper installation and use, as
well as for a general overview.
The actual component parts of the REMUS exhaust system may not entirely
correspond to the photographs and other illustrations.
REMUS takes all copyright and other rights infringement cases under serious
consideration. If you have any reason to believe that your exhaust system is not
an original REMUS product, please contact our local partners or REMUS at
office@remus.at
17