Initialization And Calibration On The Radiator Thermostat; Wifi Signal Pairing Between Smart Radiator Thermostat And Gateway - Emke Rth1W Bedienungsanleitung

2.1.2 PresstheUpositiontoremovethebatterycoverasshowninthe diagram,inserttwoAAbatteries(ensurethecorrectpolarity)
andmountthe coverbacktothethermostatcorrectly.
2.1.3 Before mounting the thermostat to valve, ensure the thermostat is on open position (the plastic plunger of the
thermostat is in open position). Thread the nut of thermostat to the valve tightly.
If your valves listed as below, please refer to the following picture
for the adaptor installation first.

2.2 Initialization and Calibration on the radiator thermostat

2.2.1 Once the batteries installed, the TRV will display ---, press icon
flashing, you can mount the thermostat to the valve now (Ensure the plastic plunger in the thermostat is in open
position before you mount the thermostat to the valve)
2.2.2 PAfter mounting the thermostat to the valve, press icon
starts automatically.
2.2.3 Once calibration is done, the display will be automatically on (you can touch the display to active it if it is dark),
now you can operate the thermostat.

2.3 Wifi signal pairing between smart radiator thermostat and gateway

Note: Before pairing radiator thermostat to the APP, please make sure the gateway has been connected to the APP
07
on the display for initialization, the display start
, the display becomes dark, simultaneously, calibration
1 Find and Click "gateway" on APPClick "Add subdevice".
5
When icon on the display stop flashing, means code
pairing is done and thermostat will be shown on the APP
screen as below pictures, you can also edit the product
name on the APP.
Note
When operating on the APP, TRV will have a delay of 3-5 seconds. This is a normal phenomenon.
because operateing the command on the APP , it will be transmitted to the GATEWAY , then
gateway passed to the thermostat, thermostat will execute the command after receive the
command. after the command is executed, it will be transmitted to the gateway, and gateway
will transmit it to the APP again.
2 3
Touch the display to active Hold and press icon
the buttons, press icon on Until icon is shown on the
the display to turn off thermostat display.
to dark display.
4
Press icon or on the
diaplay, icon start flashing.
After the interface is shown as below, you can operate the
preferred setting on the APP now
Repeat above operation, 16 radiator thermostats can be paired
with one gateway, ensure the WIFI signal is not weak for all the
smart radiator thermostats.
08