YitaHome ZSSX-V1 Bedienungsanleitung Seite 5

YITAHOME
ELECTRIC FIREPLACE SPECIFICATIONS
23 x 5 1/8 x 17 1/8 inch
58.4 x 13 x 43.6 cm
5.5kg
220V~240VAC
50Hz
1800~2000 Watts
CONTROL PANEL AND REMOTE CONTROL
The control panel is located on the top right corner of the fireplace/heater unit.
When a function is changed from the control panel or remote there will be a corresponding indicator
displayed. The indicator shows the function changed and the level selected. When the function is turned off,
the corresponding indicator will fade.
Flame
Power
Display Unit Timer Heater
TOGGLE SWITCH
The toggle switch is located on the back of the unit.
NOTE: Before using the fireplace please make sure set the toggle switch on the "I".
Set the toggle switch to the "O" if you would like to turn off the unit.
Power
Timer Weekly timer
Flame Plus
Heater Minus
Toggle switch
5
YITAHOME
Power
This button will not only put the fireplace insert in a standby mode, but also you can see the flame
effect through the screen. This will turn off all functions at once.
Timer
Pressing the timer button repeatedly will cycle through the following timer.
Settings: 30 minutes, 1 hour, 2 hours, 3 hours, 4 hours, 5 hours, 6 hours and off.
The display shows: 30-1H-2H-3H-4H-5H-6H-None.
The fireplace will automatically turn off when the timer reaches zero minute.
Flame
This button controls the flame effect. Allows you to adjust the flame to suit your mood.
Press this button to increase/decrease the flame effect.
Change the flame by pressing flame button repeatedly.
The brightness level of flame is as follows: high-medium-low -off. And the display shows L3 -L2- L1
accordingly.
Heater
The default setting temperature is 72°F (22°C).
Press the HEATER button to activate the heater, re-press it to turn off the heater.
then enter the temperature setting mode and change the temperature by repeatedly pressing the
heater button. The temperature can be switched from ON,17°C (62°F) to 27°C (82°F). "ON" indicates
the heating function is continuously on.
from Fahrenheit (F) to Celsius (C).
Weekly timer
Use the TIMER button to turn on the weekly timer.
Plus
Time and temperature increase during weekly timer setting.
Minus
Time and temperature decrease during weekly timer setting.
6