Handling The Device Properly - DS Z 02705 Gebrauchsanleitung

Handling the device properly

■ Only use the device in enclosed areas.
■ Only connect the device to a properly installed socket. The
socket must also be easily accessible after the device has
been connected. The mains voltage must correspond to the
data on the nameplate of the device. Only use proper exten-
sion cords, whose technical data correspond to those of the
device.
■ Check the device for damages prior to each use. The de-
vice may not be used if it, the mains cord or plug exhibit
visible damages. Do not use the device if it malfunctions,
has fallen down or in water.
■ Do not use any additional accessories. Use the accesso-
ries recommended by the manufacturer.
■ Turn the device off and pull the mains plug out of the socket
– if a fault occurs during operation,
– if liquids or debris end up in the device,
– before a storm,
– before you clean it.
■ If you wish to remove the mains plug from the socket, never
pull on the cable, but always on the plug.
■ The device must be deactivated when you pull the mains
plug out of the socket or insert it in the socket.
■ Never touch the device, the mains cord or plug with wet hands.
■ Lay the mains cord so that it cannot be crushed or kinked
and so that it does not come into contact with sharp edges
and hot surfaces (including those of the device).
■ Do not allow the device to fall and do not subject it to strong
percussions.
■ Do not pull or carry the device by the mains cord. Never
wind the mains cord around the device.
19 EN