Evolution R240 FAN Li Originalbetriebsanleitung Seite 8

www.evolutionpowertools.com
OPERATING INSTRUCTIONS
To install/remove the battery
To install the battery insert firmly into the tool until you
hear an audible click, ensuring the battery is fully seated
b
and latched into position.
To remove the battery depress the battery release button
a
and pull the battery out of the tool.
DC socket
Power can be supplied by an AC adaptor or battery pack.
While the DC socket supplies power, the battery pack will
stop working. Before using the DC socket, pull out the
FIG.1
rubber cap.
WARNING: When the DC socket is not in use, the rubber
cap should remain on the socket to prevent the build up of
dust.
AC Adaptor
When using an AC adaptor, insert the DC plug into the DC
socket, then plug into a mains power supply. Make sure that
the voltage rating of the main power supply corresponds
with that of the adaptor.
Hanging hook
Pull the hanging hook from the the back of the support leg
and use to hang the fan as required, ensure the fan is secure
and cannot fall.
Tilt adjusting knob
Turn both tilt adjusting knobs anti-clockwise to loosen, then
tilt fan as required and tighten screws.
Support leg
Use the support leg to stand the fan on a flat surface. The
support leg can also be used to hang the fan as required,
ensure the fan is secure and cannot fall.
Control panel (Fig.1)
Press the on/off button (a) to turn on the fan at low speed,
then press fan button (b) to cycle between high and low
speed. Press the on/off button (a) to turn off the fan.
8