Evolution R18 MLT Li Originalbetriebsanleitung Seite 2

EN
INTENDED USE OF THIS POWER TOOL
This product is a multi-tool and is used for sanding (not
for plaster/drywalls), scraping and cutting wood, plaster,
plastics and non-ferrous metals.
This product is compatible with most multi-tool
accessories.
PLEASE READ THE GENERAL POWER TOOL SAFETY
BOOKLET PROVIDED SEPARATELY BEFORE USING
THIS TOOL.
SAFETY INSTRUCTIONS FOR MULTI TOOLS
• Wear a suitable dust protection mask. The dust
produced when using this tool may be harmful to the
health of the operator or bystanders.
RESIDUAL RISKS
Even with application of safety standards and using the
tool as prescribed, certain residual risks can remain:
• Risk of personal injury due to prolonged use.
• Risk of injury caused by dust.
• Risk of injury caused by flying objects.
• Risk of burns due to accessories becoming hot.
STORAGE
• Store the device and its accessories in a dry and
dustproof location. Store it out of the reach of
children.
• Store the bits separately to avoid mechanical damage
or confusion with other tools. Protect the bits from
excessive heat (e.g. by storing near heating pipes or
steam pipes) and from UV radiation.
• If you intend to store a battery for a period without
use then store battery at room temperature (0°C
to 20°C) When storing for very long periods boost
charge the battery once per year to prevent over
discharge. The Ambient temperature range for
tool and battery use: 0°C to 40°C. The charging
temperature: 5°C to 40°C.
CLEANING
• The device must not be sprayed with water or placed
in water. Otherwise there is a risk of electric shock.
• Keep the device, its handle and the accessories clean.
Use a dry cloth or brush to do this. Do not use any
cleaning agents or solvents. They could damage the
device irreparably. Do not use water or metal objects.
MAINTENANCE
If a fault develops, disconnect the battery immediately and
contact Evolution Power Tools Customer Service. Do not
attempt to repair the tool.
PRODUCT OVERVIEW KEY
1. LED light
2. Locking pin
3. Auxillary handle port
4. Speed dial
5. Battery port
6. Auxillary handle
7. Tool release lever
8. On/off switch
9. Belt hook
10. Belt hook screw
11. Plunge cut blade
12. Scraper blade
13. Sanding pad
14. Sandpaper x2
NOISE WARNING
WARNING: The noise emissions during actual use
of the power tool can differ from the declared values
depending on the ways in which the tool is used
especially what kind of workpiece is processed.
ADDITIONAL BATTERY AND CHARGER
SAFETY WARNINGS
Please refer to the safety warnings and instructions
provided in the battery manual and the charger manual.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer
for recycling advice.