Product Parts; Maintenance And Cleaning - Stylies Fafnir Bedienungsanleitung

3. PRODUCT PARTS

①
②
③
1. Knob switch 2. Fireplace
5. Logo 6. Label
4. OPERATION INSTRUCTIONS
4.1 Plug in the appliance and turn the heat switch to "O" position, appliance standby.
4.2 Turn the heat select switch to " " position, open flame effect.
Turn the heat select switch to " " position, the heater blows warm air, working at Low with
4.3
flame effect.
4.4 Turn the heat select switch to " " position, the heater blows warm air, working at High with
flame effect.
4.5 Turn the heat select switch to " " position, the heater blows warm air, working at low.
4.6 Turn the heat select switch to " " position, the heater blows warm air, working at High.
4.7 Turn the heat select switch to "O" position to turn off the appliance.
4.8 Tip over safety switch is designed to switch the heater off in the event that it is lifted or falls
over. If the heater is placed on a very indented surface or on a carpet with exceptionally long,
soft pile the safety switch may prevent the heater from turning on. Should this happen
replace the heater on a firmer, smoother, surface.
09
④
⑤
⑥
⑦ ⑧
3. Air outlet 4. Handle
7. Power cord 8. Air inlet
5. PROTECTIVE SYSTEM
To avoid risk to human being or damage to internal components, the ceramic heater has a
security system which will automatically switch off the appliance if the heat reaches the
safety limit. If overheating occurs:
5.1 Turn the heat select switch to "O" position, turn the thermostat switch to the minimal position
and remove the plug from the socket.
5.2 Check if the air flows smoothly before the outlet and inlet, and if the appliance is put in right
position. If so, get it in order before restart the appliance.
5.3 Let the ceramic heater cool down for at least 10 minutes before you start it again.
5.4 Plug in the appliance and switch it on. If the appliance can't operate normally, remove the
plug immediately from the socket and have the ceramic heater serviced by an appointed
service only.

6. MAINTENANCE AND CLEANING

6.1 Turn the heat select switch to "O" position then turn off the appliance.
6.2 Clean the air inlet and air outlet of the appliance regularly (at least twice a year normally).
6.3 Before you clean the appliance, turn off the heater first, then remove the plug from the
socket, and wait until the appliance cools down.
6.4 Use a damp cloth to clean the surface of appliance, avoid water going inside the appliance,
dry the appliance before use or store.
Any servicing should be performed by an authorized service representative.
010