4.6
Stellen Sie den Heizwahlschalter auf die Position "
mit hoher Leistung).
4.7
Stellen Sie den Heizwahlschalter auf die Position "O", um das Gerät auszuschalten.
4.8
Der Kippschutz-Sicherheitsschalter ist so konzipiert, dass er den Heizlüfter ausschaltet, falls
dieser angehoben oder umkippt. Wenn der Heizlüfter auf einer stark unebenen Oberfläche
oder einem Teppich mit außergewöhnlich langem, weichem Flor steht, kann der Sicherhe-
itsschalter das Einschalten des Geräts verhindern. Sollte dies der Fall sein, stellen Sie den
Heizlüfter auf eine festere, glattere Oberfläche.
5. SCHUTZSYSTEM
Um Risiken für den Menschen oder Schäden an den internen Komponenten zu vermeiden,
ist der keramische Heizlüfter mit einem Sicherheitssystem ausgestattet, das das Gerät
automatisch abschaltet, wenn die Wärme den Sicherheitsbereich überschreitet. Bei
Überhitzung:
5.1
Stellen Sie den Heizwahlschalter auf die Position „O", drehen Sie den Thermostat-Schalter
auf die minimale Position und ziehen Sie den Stecker aus der Steckdose.
5.2
Überprüfen Sie, ob die Luft vor dem Auslass und Einlass gleichmäßig strömt und ob das
Gerät korrekt positioniert ist. Wenn dies der Fall ist, stellen Sie das Gerät in Ordnung, bevor
Sie es wieder einschalten.
Lassen Sie den keramischen Heizlüfter mindestens 10 Minuten abkühlen, bevor Sie ihn
5.3
erneut starten.
5.4
Stecken Sie das Gerät wieder ein und schalten Sie es ein. Wenn das Gerät nicht normal
funktioniert, ziehen Sie sofort den Stecker aus der Steckdose und lassen Sie den
keramischen Heizlüfter nur von einem autorisierten Kundendienst überprüfen.
6. WARTUNG UND REINIGUNG
6.1
Stellen Sie den Heizwahlschalter auf die Position „O" und schalten Sie das Gerät aus.
6.2
Reinigen Sie regelmäßig (mindestens zweimal im Jahr) den Lufteinlass und den Luftauslass
des Geräts.
6.3
Bevor Sie das Gerät reinigen, schalten Sie den Heizlüfter zuerst aus, ziehen Sie dann den
Stecker aus der Steckdose und warten Sie, bis das Gerät abgekühlt ist.
6.4
Verwenden Sie ein feuchtes Tuch, um die Oberfläche des Geräts zu reinigen. Vermeiden
Sie, dass Wasser ins Gerät gelangt. Trocknen Sie das Gerät, bevor Sie es wieder verwen-
den oder verstauen.
Alle Wartungsarbeiten sollten nur von einem autorisierten Servicevertreter durchge-
führt werden.
05
" (Heizgerät bläst warme Luft, arbeitet
Instruction Manual ///
! IMPORTANT INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the following:
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE
PRODUCTS DESCRIBED PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFOR-
MATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY
AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
1. PREPARATION BEFORE OPERATING
1.1
Check if the electrical voltage of the main supply and the load of the socket match the rated
voltage and power marked on the rating label of the appliance.
1.2
Check if the socket and the plug are undamaged, and put the plug well in the socket.
1.3
Put the appliance on a stable and flat surface for no risk of falling down.
1.4
Be sure that there is enough space for the ceramic heater while operating, at least 50 cm
around the appliance, and right before the air outlet, the distance should be at least 120 cm.
2. SAFETY PRECAUTIONS
2.1
Children aged 8 years or over and persons with reduced physical, sensory or mental capabil-
ities, lack of experience or knowledge may only use the appliance if they are supervised by
a person who is responsible for their safety or if they have been shown how to use the
appliance safely and they have understood the risks inherent in its use. Cleaning and
maintenance tasks may not be carried out by children without supervision.
2.2
Children should not play with the appliance. Keep the appliance and power cable away from
children under 8 years old. Keep packaging (e.g. plastic bags) away from children!
2.3
If the appliance has been dropped into water, always unplug the power cable first before
removing from the water. Have the appliance checked by a qualified service technician
before using it again.
2.4
Always switch off the appliance and unplug the power cable: whenever it is left unattended,
before assembling / disassembling,before cleaning, when it fails to work properly, and after
use. The plug must be accessible at all times.
2.5
For safety reasons, do not use accessories that are not recommended or sold by the manu-
facturer.
2.6
Never use close to water (bathtubs, sinks, etc.) Do not expose to rain or humidity.
2.7
Power supply: We advise connecting the appliance to an earth leakage circuit breaker (max.
06