Indicator Description - Xtool Safetypro Ap2 Kurzanleitung

Use xTool SafetyPro™ AP2
In AUTO mode, the purifier adjusts the airflow level based on processing materials. You can also press
switch between the four levels.
Note that AUTO mode is available only for xTool S1, M1 Ultra, F1 Ultra, and P2S.
Use with XCS
Download XCS
07
to
Use xTool SafetyPro™ AP2 on XCS
support.xtool.com/article/1646

Indicator description

Indicator Indicator status
Power indicator Solid blue
Blinking blue
Wireless connection indicator
Solid blue
Solid red
Fault indicator
A
Auto mode indicator Solid blue
Maintenance
Replace the filters
1
When a filter is reaching its end of life, XCS prompts you to purchase a new one for replacement. For steps about how to replace a
filter, see "Install the filters."
You must disconnect the power cable before replacing any filter.
Clean the cyclone
2
Generally, you need to clean the cyclone every 3 to 6 months. Alternatively, you can check the condition of the cyclone through
the windows at the top of the purifier, and clean the cyclone as needed.
(1) Remove the cyclone
You must disconnect the power cable before removing the cyclone.
Device status
Connected to power
Connecting to the machine ...
Connected to the machine
Motor blocked
■
Purifier door not closed
■
Working in AUTO mode
Purifier windows
08