Function - Quick Tools Qu853 Bedienungsanleitung

2.4. Function

Preparation
Place the circuit board in a
suitable holder above the air
outlet, as shown in the
illustration. The appropriate
distance from the PCB to the
air outlet should be 40mm.
Switch on
Before commissioning, please ensure that both switches are in OFF and COOL
mode. Only then should you
plug the mains cable into an
earthed socket and switch to
ON.
Now select the desired
temperature and set the switch
to WARM.
Finish work
When the LED starts flashing, the SET temperature has been reached.
Set the switch to COOL to cool
down the appliance.
Only switch the appliance to OFF
when the heating surface has
reached room temperature.
NOTE: Regularly remove flux
deposits from the protective grid.
170°C
250°C
Temperatureinstellung
Set the temperature to 250°C
4
USER MANUAL
Assembly
group