Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Whip System
I. Set the Unit to a higher temperature to suit your preference for light or thick
vapor 170c-220C(338F-428F).
2. Coarsely grind the desired amount of material and load it into the top of the
Connoisseur
Bowl.
A
Do not load or pack the bowl too tightly or airflow could be restricted.
3. Attach the Glass Connoisseur
bowl. Wait for approximately 3-5 minutes to prime the materials for use.
4. Inhale through
the glass mouthpiece
5. Alternately,
turn on the Fan while inhaling for an assisted
6. Periodically
stirring the bowl contents
material.
Use the provided Stirring Tool to stir the material in the chamber.
Remove the bowl from the unit before stirring.
7. Discard
used
bowl
contents
O The Dome Screen in the 3' Whip can clog and needs to be cleaned or replaced
periodically
for optimal
Balloon System
1.Set the Unit to a higher temperature to suit your preference for light or thick
vapor 170C-220C (338F-428F).
2. Coarsely grind the desired amount of material and load it into the top of the
Connoisseur
Bowl.
A
Do not load/pack the bowl too tightly or airflow could be restricted.
Always load from the top of the Bowl and never load both bowl chambers at the
same
time.
3. Attach
the loaded
Glass Connoisseur
whip to the bowl. Wait for approximately
use.
4. Attach the balloon mouthpiece
5. Activate the Fan to your preferred
6. Detach the balloon from the mini-whip,
Balloon Mouthpiece. Seal the balloon between draws using the silicone Balloon
Cap to prevent leakage.
18
Bowl to the unit, then attach the 3' Whip to the
in a slow, steady draw.
will help get the most out of your
and
refill
as desired.
performance.
Bowl to the unit,
3-5 minutes to prime the materials
to the mini-whip.
speed and allow the balloon to fill with vapor.
then inhale through
draw.
then attach
the mini-
for
the Frosted Glass
Whip System
Balloon System
Werbung
