INTRODUCTION
• Read the operating
this book-let
SAFETY
• This protection
• Ensure that the protection
Dirt on the protection
• CAUTION! Do not attempt to fit the cover in windy conditions!
• Do not use on newly painted or varnished
• Only use on dry vehicles.
• Do not use on a vehicle where detergents
• Never use your caravans
• Do not apply the cover if the vehicle
• Always pull the protection
• When fitting the vehicle
(no engine running).
• Keep away from children
• Use this product
• Never
• Ensure that the protection
these instructions
PLACEMENT
• Please remove all protrusions where possible, including the nosewheel
fitted with a status aerial, the top spike must be removed
• It's recommended that the caravan or camper is cleaned and free Of any loose particles/grit, prior to fitting
• Avoid the inside surface of the cover coming into contact with the ground. It's important to protect windows
from scratching
• Note! Any Sharp protruding objects will tear/damage the cover and shorten its useful life. It's your
responsibility to ensure all sharp objects are suitably covered, thus preventing damage to your cover.
• Two people and the careful use of stepladders are necessary to fit the cover Starting from the front, lift the
cover over the roof of the caravan or camper, being careful not to snag the cover on any protruding objects,
n
such as aerials or heater vents. Once in position, adjust as necessary for an even fit side to side
Tip: Use the end of a broom to fit the cover over the roof.
• Feed the nylon spanner underneath the vehicle in such a way that they are not twisted, click in the clasps
and draw tight
• ATTENTION: Avoid direct contact with windows and/or other fragile parts of the vehicle to prevent scratching
(after placement the nylon straps can vibrate/rattle because Of wind). The use separators and corner guards
when needed is strongly advised
• A piece of spare material is co-supplied to use for repairs in the unexpected event of a tear
Recommended
The spacers and protective comers (sold separately, art.nrs. 610266 and 610267) are used to guide the
straps to avoid contact with the vehicle and as a force distributor on the fragile edges of the vehicle and
it will prevent scratches.
MAINTENANCE
• Allow the cover to dry completely before storing in the bag provided.
• Do not machine wash or tumble dry the cover. Remove dirt with soft sponge and warm water.
• The cover can- be cleaned with lukewarm water with a brush or a sponge. Let it dry before using it again.
• Do not use detergents or shampoos!
• Do not tow your caravan with the cover fitted.
Attention
The harmful effect of UV radiation caused by exposure to bright sunlight generally has an adverse impact
on the life
To extend the life of the product, we recommend you place it in a shady place.
instructions
for
later
reference.
INSTRUCTIONS
cover should
not be used for temperatures
cover and the vehicle are dry and clean before assembly.
cover or vehicle
or campers gas heating system when the cover is fitted!
cover over the vehicle
must be on the brakes and on a flat surface and to be disabled
and do not let children
only for the provided
use
on
a human
or
animal!
cover is attached correctly
are not observed
use: Spacers
of the materials.
carefully
before using the appliance
may cause scratching
vehicles.
and I or a protective
is still warm (chimney,
carefully.
play with the top cover!
use!
to the vehicle.
or followed
correctly!
(not included)
4
for the first time and preserve
below -200C and above +500 C!
or damage the car paint.
coating
are applied.
engine, exhaust,
etc.)
We will accept no liability
If your caravan or camper is
if