VEVOR JW-301 Bedienungsanleitung Seite 7

(see 1B). lf you are unable to turn the mount ring, tap on one of the extensions
from the ring with a hammer.Some mounting systems have tubular extensions.
Inserting a screwdriver into one tube will provide additional leverage for turning the
mount ring (see 1B).Some disposers may require the removal or loosening of nuts
from the mount screws (see 1C). Some disposers may require the removal of a
clamp.
Caution: Be sure to support the disposer while performing this step or it may fall
when the mounting ring is disconnected from the mounting assembly. lf your
disposer is hard wired (metal shielded cable not utilizing a wall plug),complete
steps C and D. lf you utilize a plugin cord, go on to step E.
C. When disposer is removed, turn up side down and remove electrical cover
plate(see 1D).
D. Use screwdriver to remove green ground wire. Remove wire nuts from black
and white power wires and separate disposer wires from power cable wires.
Loosen screws on cable clamp and separate cable from disposer.
E. To remove remaining mount system from the sink,loosen mount screws, push
mount ring up.Under it is the snap ring.Use screwdriver to pop off ring (see 1E).
Remove mount ring, protector ring and gasket from sink flange. Some mounts will
require the unscrewing of a large ring holding the sink flange in place. Pull sink
flange up through sink and clean off old putty from sink.
IMPORTANT: Unless you have a new home, this is a good time to clean out
the trap and drain lines by running a drain auger or plumber's snake before
installing your new disposer.
- 6 -