Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Switch the circuit breaker of the power circuit back on again.
•
The dimming actuator is now ready for operation and can be
connected to the Homematic IP access point (see see „6.4 Pair-
ing" on page 37).
6.4
Pairing
Please read this entire section before starting the pairing proce-
dure.
First set up your Homematic IP access point via the Homematic IP
app to enable operation of other Homematic IP devices within your
system. For further information, please refer to the operating manu-
al of the access point.
To integrate the device into your system and enable it to communi-
cate with other Homematic IP devices, you must first add the device
to your Homematic IP access point.
To add the device, please proceed as follows:
•
Open the Homematic IP app on your smartphone.
•
Select the menu item "Add device".
•
After installation, the pairing mode remains activated for 3 min-
utes.
If the time has exceeded, you can manually restart the pairing mode
for another 3 minutes by removing the rocker and pressing the sys-
tem button (A) briefly with a pointed object (see figure 9).
•
Your device will automatically appear in the Homematic IP app.
•
To confirm, enter the last four digits of the device number
(SGTIN) in your app or scan the QR code. The device number can
be found on the sticker supplied or attached to the device.
•
Wait until pairing is completed.
•
If connecting was successful, the LED (A) lights up green. The
device is now ready for use.
•
If the LED lights up red, please try again.
•
Select the desired solution for your device.
•
In the app, give the device a name and allocate it to a room.
Start-up
37
Werbung
