Werbung
Each time you enter the programming mode you are allowed to make one change and then you
will automatically exit the programming mode. To change more than one parameter you will have
to re-enter the programming mode each time.
1. Bremse / Brake
Im Unterschied zu allen weiteren Einstellungen wird der „Bremsmodus" gewechselt, wenn
Sie unmittelbar nach der ersten Tonfolge den Gasknüppel in die Motor-Aus-Position
bringen. (ON -> OFF, oder OFF -> ON)
To change the brake function, as soon as you hear the programming tones mentioned
above, move the throttle stick to low position. Brake function will be inverted. (IE: If brake
was on, it now will be off.)
To change any of the remaining functions, enter the programming mode as detailed above.
Leave the throttle at high position until you are within the five sets of beeps as detailed in
each of the choices below. When you arrive at the choice you want to make, move the
throttle to low position while that series of 5 tones are still being heard.
2. Akku Typ / Battery type
(Abschaltspannung) / (Voltage Cut-off)
NiCad:! !
2 Lipos: (5.8V)!
3 Lipos: (8.3V)!
Folgende Einstellmöglichkeiten nur bei OPTO-Versionen:
Following options only on OPTO-controllers:
4 Lipos: (11.3V)!
5 Lipos: (14.2V)!
3.Abschaltsystem bei Unterspannung / Under voltage
Abregelung / reduces power when the battery gets low.!
Abschaltung / cuts off power when the battery getslow.!
4. Gasannahme / Acceleration
Schnell / Fast:! !
Verzögert / Delayed:! !
5. Timing / Timing
Automatic: (7 ~ 30 degree) ( empfohlen / recommended)! !
Soft: (7 degree) (2-Polige Motoren / 2-pole motors)! !
Hard (22 ~ 30 degree) (Hochpolige Motoren / multipole motors)! !
6. Schaltfrequenz / Frequency
8 kHz: ( empfohlen / recommended)! !
!
. . . . .
.. .. .. .. ..
... ... ... ... ...
.... .... .... .... ....
..... ..... ..... ..... .....
!
V V V V V
VV VV VV VV VV
Copyright 01/10 – Hacker Motor GmbH Seite / Page 4
-_ -_ -_ -_ -_
_- _- _- _- _-
!
\ \ \ \ \
!
- - - - -
!
-- -- -- -- --
--- --- --- --- ---
Werbung
