PROFI CARE PC-HR 3023 Bedienungsanleitung, Garantie Seite 43

Using the Long Hair Cutter
With the long hair cutter, you can trim head hair or beard
hair in a controlled manner.
• Slide down the unlocking to unfold the long hair cutter.
• In order to close the long hair cutter push it back down. It
must audibly snap.
WARNING:
• Before cleaning the handset with water, disconnect it from the
connection cable.
• Turn off the appliance and disconnect the power adapter from
the mains supply when cleaning.
• Do not immerse the appliance and the power adapter into water.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
Shaving Head
Cleaning after each Use
You may clean the shaving head under running water.
1. Press the unlock button for the shaving head. Remove
the shaving head.
2. Rinse the shaving head under hot running water. Clean
the shaving head in soapy water once in a while.
NOTE:
Do not clean the appliance with water of over 60 °C.
3. Rinse thoroughly with clear water afterwards.
4. Let the cleaned parts dry.
5. Place the shaving head back onto the handpiece. It must
audibly snap.
Alternatively, you may clean the shaving head with the
brush provided.
CAUTION:
The shaving foils must not be cleaned with the brush!
Monthly cleaning
Thoroughly clean the shaving head once a month. If neces-
sary, use special cleaning aids available in specialist shops.
1. Press the unlock button for the shaving head. Remove
the shaving head.
2.
WARNING: Risk of Injuries!
The shear blades are sharp!
PC-HR3023_IM_new
End of Operation
Press the button to switch the appliance off.
NOTE:
The display will go blank after approx. 5 seconds.
Cleaning
Disassemble the shaving head. Please refer to the over-
view on page 3. Proceed as follows:
2.1. Unscrew the unlocking of the shaving foil fixer in the
direction of the arrow.
2.2. Remove the shaving foil fixer by pulling it up.
2.3. Remove the shaving foils and shear blades.
3. Rinse all parts of the shaving head under hot running
water. Occasionally clean these parts in a soap solution.
4. Rinse thoroughly with clear water afterwards.
5. Let the cleaned parts dry.
6. Put the shaving head back together in reverse order.
7. Lubricate the shaving foils using light machine oil (a few
drops are sufficient).
Cleaning the Hand-held Unit and Power Adapter
• You may wipe these parts with a damp cloth.
• Use slightly soapy water to remove spots.
Changing the Shaving Head
To maintain the shaving performance at 100 %, replace the
shaving head at the latest every 18 months or when the
shear parts show wear.
For replacement parts, please consult your dealer.
• Clean the appliance as described and allow it to dry.
• We recommend that the appliance is kept in its original
packaging if you do not intend to use it for long periods.
• Always store the appliance out of the reach of children,
in a well-ventilated and dry place.
Storage
19.03.21
43