Stopping Charging - Em2Go Take11 Bedienungsanleitung

GB
Fig.4 Fig.5

Stopping charging

In charging mode, touch the power button and the time button
seconds to stop charging. Repeat this process to resume charging.
Troubleshooting
If there is a fault in the device, an error code will appear on the display.
Example: If the residual current circuit breaker (RCD) has tripped, the display will show: "01", where
"01" is the error code.
Fault information LED Handling method
• Turn off the device and check the electric car
Code 01: Leakage current, Flashes
and the charger.
residual current circuit 1 x
breaker (RCD) has tripped
Code 02: Overcurrent Flashes • Turn off the device and check the electric car.
protection activated 2 x
Code 03:Earth fault Flashes • Turn off the device and check the power supply.
protection activated 3 x
Code 04: Overvoltage/ Flashes • Turn off the device and check the power supply.
undervoltage protection 4 x
activated
• Please contact our support team.
Code 05: Welding fault Flashes
protection activated 5 x
Code 06:Communication Flashes • Check that the plugs are fi rmly seated.
error (between control unit 6 x Try reconnecting the cables.
and vehicle)
Code 07: Overheating Flashes • Check the heat dissipation of the housing.
7 x
Code 08: Diodes loss Flashes • Check the EV CP diodes.
8 x
Cleaning
Before cleaning, disconnect the device from the power supply and use a dry cloth for cleaning.
For stubborn stains, use a mild detergent and a damp cloth, then wipe the device with a dry cloth.
Storage
Disconnect the cable from the power supply. Store the device in a dry, cool place. We recommend
storing it in the bag provided.
11
Fig6
at the same time for more than 3
Warranty and Maintenance
The warranty period for this charger is two years.
•
The warranty is void if:
•
No proof of purchase can be provided.
•
The warranty period specifi ed by the manufacturer is exceeded.
•
The instructions for use, maintenance and storage are not followed.
•
Damage or malfunction is caused by the ingress of foreign objects.
•
In case of repair, disassembly or modifi cation by unauthorized persons.
•
Damage caused by force majeure (such as lightning, overvoltage, earthquake, fi re, fl ood, etc.).
•
Damage and malfunctions caused by other avoidable external factors.
•
Damage and malfunction caused by improper use of the equipment, such as the ingress of water
•
or other liquids.
Damage and malfunctions are caused by the mains power supply and a voltage that is not
•
specifi ed for use with the charger.
No liability will be accepted for any damage caused by incorrect operation. If you need technical
support, please contact our support team via our website www.em2go.de.
We hereby declare, that this device carries the CE mark in accordance with the
regulations and standards. It conforms with the fundamental requirements of the of
EMC Directive 2014/30/EU, and the Low Voltage Directive 2014/35/EU.
The full text of the EU declaration of conformity is available at the following internet
address: www.em2go.de/Konfo
Note on environmental protection:
After the implementation of the European Directive 2012/19/EU in the national legal
system, the following applies:
Electrical and electronic devices may not be disposed of with domestic waste.
Consumers are obliged by law to return electrical and electronic devices at the end
of their service lives to the public collecting points set up for this purpose or point of sale.
Details of this are defi ned by the national law of the respective country. This symbol on the product,
the instruction manual or the package indicates that a product is subject to these regulations. By
recycling, reusing the materials or other forms of utilising old devices, you are making an important
contribution to protecting our environment.
GB
12