STARLINK Short Bedienungsanleitung Seite 8

INSTALLATION
Instructions
Unplug your Starlink from wall before beginning the
installation process.
1. Plan your install. Use a stud finder to locate a stud
on an exterior wall. Ensure location will allow the
Starlink to fully rotate without hitting the roof.
NOTE: Prior to your permanent install, use the Lawn Mount in the
internet kit to perform an initial setup of the Starlink. Note the
direction and tilt of the Starlink and ensure your final install location
will provide a clear view for this orientation.
2. Place mount over stud and make two center
marks on wall, making sure Starlink is 5
degrees within level.
3. Drill pilot holes into the two center marks
and insert the silicone sealant into the holes.
4. Place mount over holes and insert screws. Use
the drill with socket to drive screws in 90%; do not
overdrive. Use socket wrench to tighten screws
plus ¼ turn; do not overtighten.
> 4 in/100 mm
1 in/25 mm
ENGLISH